Motorola Solutions인증 MSC-122시험을 가장 빠른 시일내에 가장 쉬운 방법으로 패스하는 방법을 고심초사한끝에 ITExamDump에서 연구해 내었습니다. 그건 바로ITExamDump의Motorola Solutions인증 MSC-122덤프로Motorola Solutions인증 MSC-122시험에 대비하는것입니다. ITExamDump의Motorola Solutions인증 MSC-122덤프품질을 검증하려면 구매사이트의 무료샘플을 체험해보시면 됩니다.자격증을 많이 취득하여 멋진 IT전문가로 되세요.
IT인증자격증을 취득하려고 마음먹었으면 끝까지 도전해봐야 합니다. Motorola Solutions인증 MSC-122시험이 아무리 어려워도ITExamDump의Motorola Solutions인증 MSC-122덤프가 동반해주면 시험이 쉬워지는 법은 많이 알려져 있습니다. ITExamDump의Motorola Solutions인증 MSC-122덤프는 100% 패스보장 가능한 덤프자료입니다.한번만 믿어주시고ITExamDump제품으로 가면 시험패스는 식은 죽 먹기처럼 간단합니다.
시험 번호/코드: MSC-122
시험 이름: Motorola Solutions (Deploy WLAN Solutions)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 113 문항
업데이트: 2014-04-20
ITExamDump덤프공부가이드는 업계에서 높은 인지도를 자랑하고 있습니다. ITExamDump제품은 업데이트가 가장 빠르고 적중율이 가장 높아 업계의 다른 IT공부자료 사이트보다 출중합니다. ITExamDump의Motorola Solutions인증 MSC-122덤프는 이해하기 쉽고 모든Motorola Solutions인증 MSC-122시험유형이 모두 포함되어 있어 덤프만 잘 이해하고 공부하시면 시험패스는 문제없습니다.
Motorola Solutions인증 MSC-122시험은 등록하였는데 시험준비는 아직이라구요? Motorola Solutions인증 MSC-122시험일이 다가오고 있는데 공부를 하지 않아 두려워 하고 계시는 분들은 이 글을 보는 순간 시험패스에 자신을 가지게 될것입니다. 시험준비 시간이 적다고 하여 패스할수 없는건 아닙니다. ITExamDump의Motorola Solutions인증 MSC-122덤프와의 근사한 만남이Motorola Solutions인증 MSC-122패스에 화이팅을 불러드립니다. 덤프에 있는 문제만 공부하면 되기에 시험일이 며칠뒤라도 시험패스는 문제없습니다. 더는 공부하지 않은 자신을 원망하지 마시고 결단성있게ITExamDump의Motorola Solutions인증 MSC-122덤프로 시험패스에 고고싱하세요.
MSC-122 덤프무료샘플다운로드하기: http://www.itexamdump.com/MSC-122.html
NO.1 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C
Motorola Solutions MSC-122자격증 MSC-122 MSC-122
NO.2 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C
Motorola Solutions자료 MSC-122 dumps MSC-122최신덤프 MSC-122자격증
NO.3 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D
Motorola Solutions기출문제 MSC-122 MSC-122 MSC-122 MSC-122 dump
NO.4 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A
Motorola Solutions MSC-122 MSC-122 MSC-122 MSC-122
NO.5 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A
Motorola Solutions MSC-122시험문제 MSC-122자료 MSC-122
NO.6 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D
Motorola Solutions MSC-122덤프 MSC-122자료 MSC-122
NO.7 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B
Motorola Solutions덤프 MSC-122기출문제 MSC-122기출문제 MSC-122 dumps MSC-122기출문제
NO.8 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A
Motorola Solutions자격증 MSC-122최신덤프 MSC-122 pdf MSC-122 MSC-122
NO.9 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B
Motorola Solutions덤프 MSC-122 MSC-122
NO.10 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A
Motorola Solutions MSC-122 MSC-122 pdf MSC-122
NO.11 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C
Motorola Solutions MSC-122 dumps MSC-122 MSC-122
NO.12 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D
Motorola Solutions인증 MSC-122 dump MSC-122최신덤프 MSC-122
NO.13 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A
Motorola Solutions자료 MSC-122최신덤프 MSC-122 MSC-122최신덤프
NO.14 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B
Motorola Solutions MSC-122 MSC-122덤프 MSC-122인증 MSC-122
NO.15 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C
Motorola Solutions MSC-122 MSC-122자격증 MSC-122기출문제 MSC-122
ITexamdump의 HP2-N44덤프의 VCE테스트프로그램과 1Z1-061덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 HP3-C33시험에 대비한 고품질 덤프와 MSC-331시험 최신버전덤프를 제공해드립니다. 최고품질 HP0-Y46시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기