ITExamDump에서 출시한 Juniper인증JN0-532 덤프는 시험문제점유율이 가장 높은 시험대비자료입니다. 실제Juniper인증JN0-532시험문제유형과 같은 형식으로 제작된Juniper인증JN0-532 시험공부자료로서ITExamDump덤프의 실용가치를 자랑하고 있습니다.덤프를 공부하여 시험불합격하시면 덤프비용은 환불처리해드립니다.
Juniper 인증 JN0-532시험에 도전해보려고 결정하셨다면 ITExamDump덤프공부가이드를추천해드립니다. ITExamDump덤프는 고객님께서 필요한것이 무엇인지 너무나도 잘 알고 있답니다. ITExamDump의 Juniper 인증 JN0-532덤프는Juniper 인증 JN0-532시험을 쉽게 만듭니다.
ITExamDump는 여러분이 빠른 시일 내에Juniper JN0-532인증시험을 효과적으로 터득할 수 있는 사이트입니다.Juniper JN0-532인증 자격증은 일상생활에 많은 개변을 가져올 수 있는 시험입니다.Juniper JN0-532인증 자격증을 소지한 자들은 당연히 없는 자들보다 연봉이 더 높을 거고 승진기회도 많아지며 IT업계에서의 발전도 무궁무진합니다.
Juniper인증JN0-532시험은 국제적으로 승인해주는 IT인증시험의 한과목입니다. 근 몇년간 IT인사들에게 최고의 인기를 누리고 있는 과목으로서 그 난이도 또한 높습니다. 자격증을 취득하여 직장에서 혹은 IT업계에서 자시만의 위치를 찾으련다면 자격증 취득이 필수입니다. Juniper인증JN0-532시험을 패스하고 싶은 분들은ITExamDump제품으로 가보세요.
시험 번호/코드: JN0-532
시험 이름: Juniper (FWV,Specialist (JNCIS -FWV))
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 146 문항
업데이트: 2014-03-02
목표를 이루는 방법은 여러가지가 있는데 어느 방법을 선택하면 가장 빨리 목표를 이룰수 있을가요? Juniper인증 JN0-532시험을 패스하는 길에는ITExamDump의Juniper인증 JN0-532덤프를 공부하는 것이 가장 좋은 방법이라는것을 굳게 약속드립니다. ITExamDump의Juniper인증 JN0-532덤프는 시험문제에 초점을 두어 제작된 공부자료이기에Juniper인증 JN0-532패스를 가장 빠른 시일내에 한방에 할수 있도록 도와드립니다.
JN0-532 덤프무료샘플다운로드하기: http://www.itexamdump.com/JN0-532.html
NO.1 Click the Exhibit button.
In the exhibit, which two can be determined about the VPN? (Choose two.)
A.NAT-traversal is enabled.
B.The rekey interval is 8 hours.
C.This device initiated the Phase 1 negotiations.
D.The certificate used in this exchange is set to never expire.
Answer: BC
Juniper JN0-532 JN0-532 JN0-532 JN0-532
NO.2 During main mode negations a failure has occurred while using IKE certificates.
Which message pair would you review to troubleshoot this failure?
A.messages 1 & 2
B.messages 2 & 3
C.messages 3 & 4
D.messages 5 & 6
Answer: D
Juniper자격증 JN0-532덤프 JN0-532기출문제 JN0-532
NO.3 What must be configured differently for a route-based VPN and a policy-based VPN?
A.proxy-id
B.proposals
C.remote gateway type
D.binding the tunnel interface
Answer: D
Juniper pdf JN0-532 dumps JN0-532 JN0-532시험문제 JN0-532
NO.4 You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS
using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr.
What is the status of the virtual router after you create the VSYS?
A.The router will be the default router but will no longer be shared.
B.The router will be the default router and will still have a shareable status.
C.The system will not let you use a shared virtual router when you create a new VSYS. The initial virtual
router must be private.
D.The system will not create a private vr for the VSYS but will assign the untrust-vr as the default router.
The shared Virtual router will not be the default router.
Answer: B
Juniper pdf JN0-532 JN0-532시험문제
NO.5 What must be enabled to protect Phase 2 key exchanges?
A.Phase 1 PFS
B.Phase 2 SHA
C.Phase 2 3-DES
D.Phase 2 DH key exchange tiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: D
Juniper인증 JN0-532 dumps JN0-532덤프
NO.6 Which command is used to verify that IGMP is running correctly?
A.get route igmp
B.get igmp query
C.set igmp query interface e0/1
D.exec igmp interface e0/1 query
Answer: D
Juniper dumps JN0-532인증 JN0-532
NO.7 Review the exhibit.
You've been asked to build a route-based hub and spoke network, with policy control for traffic travelling
from spoke to spoke. Which two of the following configuration options will meet this requirement?
(Choose two.)
A.Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
B.Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
C.Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
D.Create separate tunnel interfaces at the hub and place them in different zones, then create policies at
the hub.
Answer: BD
Juniper JN0-532 JN0-532 dumps JN0-532
NO.8 Click the Exhibit button.
Review the exhibit. Track-ip has failed on the device, but the device did not fail over to the second unit in
the cluster:
Why has failover not occurred?
A.The physical interfaces have not failed.
B.The track-ip interval is not sufficient to cause failover.
C.The track-ip address weight is not sufficient to cause failover.
D.The track-ip address threshold is not sufficient to cause failover.
Answer: C
Juniper dumps JN0-532 JN0-532최신덤프
NO.9 Click the Exhibit button.
In the exhibit, what is the source IP address of the multicast traffic?
A.236.1.1.1
B.10.10.10.1
C.20.20.20.10
D.20.20.20.200
Answer: B
Juniper JN0-532덤프 JN0-532자료 JN0-532최신덤프 JN0-532 pdf
NO.10 Click the Exhibit button.
In the exhibit, the firewall administrator at the Storefront is complaining that when the communication to
the DataCenter1 fails, the preexisting transfers and applications are dropped when the traffic is switched
to DataCenter2.
Which statement explains this behavior?
A.SYN checking is enabled in the tunnel.
B.The weight value for the DataCenter2 is too high.
C.VPN monitor is misconfigured in the DataCenter2.
D.Phase 1 and Phase 2 negotiations to DataCenter2 did not occur on time.
Answer: A
Juniper시험문제 JN0-532자료 JN0-532자격증 JN0-532
NO.11 Which three statements are true regarding IKE Phase 1? (Choose three.)
A.Placing the SA proposal list in message 1 is an option.
B.The digital certificate is used to decrypt the session key.
C.The DH key exchange is used to validate the session key.
D.The DH key exchange and digital certificates are both optional.
E.The proxy-id is used to determine which SA is referenced for the VPN.
Answer: ABC
Juniper최신덤프 JN0-532최신덤프 JN0-532 JN0-532 dumps
NO.12 Which ScreenOS CLI command is necessary for configuring IGMP on interface ethernet0/1?
A.set igmp interface ethernet0/1
B.set multicast interface ethernet0/1
C.set interface ethernet0/1 igmp router
D.set igmp interface ethernet0/1 enable
Answer: C
Juniper JN0-532 dump JN0-532
NO.13 To which three ScreenOS components can a policy-based routing policy be bound? (Choose three.)
A.zone
B.policy
C.interface
D.virtual router
E.virtual system
Answer: ACD
Juniper JN0-532 JN0-532 dump JN0-532
NO.14 Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: AD
Juniper JN0-532 JN0-532자료 JN0-532 JN0-532 JN0-532자료
NO.15 You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
What will be the resulting output in the debug for which this was created?
A.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be
captured
B.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be
captured
C.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will
be captured
D.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will
be captured
Answer: C
Juniper JN0-532인증 JN0-532 dump JN0-532 dumps JN0-532인증
NO.16 Which CLI command identifies the multicast sources visible to your ScreenOS device?
A.get route pim
B.get igmp source all
C.exec pim interface all query
D.get vrouter trust-vr protocol pim
Answer: D
Juniper인증 JN0-532자격증 JN0-532 dump JN0-532
NO.17 You have configured the following on your device.
set address trust MyPC 10.1.1.5/32
set address untrust CorpNet 10.10.0.0/16
set policy from trust to untrust MyPC CorpNet any permit
set int tunnel.1 zone untrust
set int tunnel.1 ip unnumbered int bgroup1
set ike gateway GW address 1.1.1.1 outgoing-interface e0/1 preshare Secret sec-level standard
set vpn VPN gateway GW sec-level standard
The tunnel interface is down, so the VPN cannot function properly. What is the problem?
A.The policy needs to have the action tunnel.
B.The VPN needs to be bound to the tunnel interface.
C.The tunnel interface needs to be placed in the trust zone.
D.The tunnel interface needs to be associated with the interface in the untrust zone.
Answer: B
Juniper JN0-532 JN0-532 pdf JN0-532 dumps
NO.18 Which three OSPF parameters are interface parameters? (Choose three.)
A.cost
B.priority
C.neighbor list
D.summarization
E.advertise default route
Answer: ABC
Juniper pdf JN0-532 JN0-532최신덤프 JN0-532 pdf JN0-532 dumps
NO.19 Click the Exhibit button.
In the exhibit, what is the address of the multicast receiver?
A.234.9.8.42
B.192.168.10.2
C.192.168.20.10
D.192.168.20.200
Answer: D
Juniper JN0-532 dump JN0-532 JN0-532자료 JN0-532
NO.20 Review the exhibit.
Which two of the following elements must be configured on the ScreenOS device in order to support
PIM-SM? (Choose two)
A.A multicast control policy
B.A bootstrap router process
C.A unicast routing protocol
D.A static RP
Answer: AC
Juniper JN0-532인증 JN0-532 JN0-532자격증
ITexamdump의 70-489덤프의 VCE테스트프로그램과 BAS-013덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 C_TFIN22_64시험에 대비한 고품질 덤프와 HP2-E58시험 최신버전덤프를 제공해드립니다. 최고품질 JN0-533시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기